把路由刷成砖了，怎么办？
现在路由不停的重启，没有ip地址了。连接usb串口是这样的，该怎么办？THIS IS ASIC
Linux version 2.6.36 (root@asus) (gcc version 4.2.4) #808 Fri Aug 7 17:21:52 CST 2015
The CPU feqenuce set to 580 MHz
ramsize = 64 MBytes
rambase not set, set to default (0x00000000)
PCIE: bypass PCIe DLL.
PCIE: Elastic buffer control: Addr:0x68 -> 0xB4
disable all power about PCIe
C MT7620N
CPU revision is: 0MIoftware DMA cache coherency
Determined physical RAM map:
memory: 04000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00004000
Movable zone start PFN for each node
early_node_map active PFN ranges
0: 0x00000000 -> 0x00004000
Built 1 zonelists in Zone order, mobility grouping off.Total pages: 16256
Kernel command line: console=ttyS1,115200n8 root=/dev/mtdblock4 rootfstype=squashfs noinitrd
PID hash table entries: 256 (order: -2, 1024 bytes)
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Primary instruction cache 64kB, VIPT, , 4-waylinesize 32 bytes.
Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes
Writing ErrCtl register=000265dc
Readback ErrCtl register=000265dc
Memory: 61332k/65536k available (2715k kernel code, 4204k reserved, 569k data, 176k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:128
init_r4k_clocksource: cpu_has_counter(128) mips_hpt_frequency(290000000)
new mips_hpt_frequency(289260310)
console enabled
Calibrating delay loop... 386.04 BogoMIPS (lpj=772096)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 512
NET: Registered protocol family 16
RALINK_GPIOMODE = 1a311c
RALINK_GPIOMODE = 18311c
PPLL_CFG1=0x4010000
MT7620 PPLL unlock
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 1, 8192 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
RT3xxx EHCI/OHCI init.
squashfs: version 4.0 (2009/01/31) Phillip Lougher
JFFS2 version 2.2 (NAND) (ZLIB) (RTIME) (c) 2001-2006 Red Hat, Inc.
msgmni has been set to 119
Block layer SCSI generic (bsg) driver version 0.4 loaded (major 254)
io scheduler noop registered (default)
HDLC line discipline maxframe=4096
N_HDLC line discipline registered.
Ralink gpio driver initialized
Serial: 8250/16550 driver, 2 ports, IRQ sharing disabled
serial8250: ttyS0 at MMIO 0x10000500 (irq = 37) is a 16550A
serial8250: ttyS1 at MMIO 0x10000c00 (irq = 12) is a 16550A
brd: module loaded
Ralink SPI flash driver, SPI clock: 48MHz
deice id : c2 20 17 c2 20 (2017c220)
MX25L6405D(c2 2017c220) (8192 Kbytes)
mtd .name = raspi, .size = 0x00800000 (8M) .erasesize = 0x00010000 (64K) .numeraseregions = 0
partion 3: ffffffff 7b0000
partion 4: 1736c0 68c940
#add mtd partition#
Creating 6 MTD partitions on "raspi":
0x000000000000-0x000000030000 : "Bootloader"
0x000000030000-0x000000040000 : "nvram"
0x000000040000-0x000000050000 : "Factory"
0x000000050000-0x000000800000 : "linux"
0x0000001736c0-0x000000800000 : "rootfs"
0x000000000000-0x000000800000 : "ALL"
rdm_major = 253
Allocate 4096 entries coherent memory for hw_nat. (262144 bytes)
SMACCR1 -- : 0x00000011
SMACCR0 -- : 0xf7a76c54
Ralink APSoC Ethernet Driver Initilization. v3.1512 rx/tx descriptors allocated, mtu = 1500!
SMACCR1 -- : 0x00000011
SMACCR0 -- : 0xf7a76c54
PROC INIT OK!
PPP generic driver version 2.4.2
PPP Deflate Compression module registered
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPTP driver version 0.8.5
IMQ driver loaded successfully.
Hooking IMQ before NAT on PREROUTING.
Hooking IMQ after NAT on POSTROUTING.
u32 classifier
nf_conntrack version 0.5.0 (958 buckets, 3832 max)
matchsize=264
xt_time: kernel timezone is -0000
GRE over IPv4 demultiplexor driver
gre: can't add protocol
ip_tables: (C) 2000-2006 Netfilter Core Team, Type=Linux
arp_tables: (C) 2002 David S. Miller
TCP cubic registered
NET: Registered protocol family 10
ip6_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 17
L2TP core driver, V2.0
PPPoL2TP kernel driver, V2.0
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly on device 31:4.
Freeing unused kernel memory: 176k freed
offset 0x6000 elapse 0ms
set_action 0
Hit ENTER for console...
Algorithmics/MIPS FPU Emulator v1.5
/ #
/ #
/ #
/ #
/ #
/ #
/ #
/ #
请参考教程http://www.52asus.com/thread-34-1-2.html以及http://www.52asus.com/thread-92-1-1.html 你这是干了啥 还能正常启动bootloader,说明还没完全挂,用救援模式刷固件即可 zfwaitingforyou 发表于 2015-10-15 17:35
还能正常启动bootloader,说明还没完全挂,用救援模式刷固件即可
如何进救援模式？ shy_mon 发表于 2015-10-18 10:29
如何进救援模式？
http://www.52asus.com/thread-34-1-2.html
请参照教程帖
页:
[1]